Quick steam generator ARTO/D

Horizontal or vertical helical coil, of water tube design. Three-pass design ensures a ‘’cool’’ furnace.

Quick- steam generators

ARTO/D type quick steam generators are suitable for all traditional oil and gaseous fuels.

ARTO/D quick generators are constructed and tested in accordance with the P.E.D 2014/68/EUrelative to the pressure equipment (PED)

Design based on the water-tube principle, in which the feed water is heated and evaporated in one pass.
Water quickly changes into steam. Steam within minutes.
Heating coil easily removable.
Dry saturated steam
Easy maintenance
Insulation made of high density mineral wool, protected by aluminium steel sheet
Low fuel consumption
High efficiency up to 91%. The use of an economizer can increase the boiler efficiency even more than up to 95%
Durability

Standard equipment

Pre-wired electrical control panel
Three-piston feed water pump with suction boost pump.
Main steam valve bellow sealed type
Steam dryer
Full stroke safety valve spring type
Steam working pressure limiter
Second working steam pressure limiter for the modulating operation of the burner.
Steam safety pressure limiter.
Water pressure limiter, through which a siren is set off so that the burner stops working if the water pressure is 35-40% more than the steam generator’s working pressure.
Feed water valve bellow sealed type
Non return disk valve for the water feed inlet
Manual blow down valve
Pressure gauge
Glycerin manometer 0-16 bar for the water inlet pressure before the three-piston pump
Glycerin manometer 0-40 bar for the water inlet pressure after the three-piston pump
Steam temperature control system, which sets off the siren and interrupts the operation of the burner if the steam temperature rises over the accepted limits.

Apart from the above mentioned armatures of the steam generator, ARTEMIS S.A. can also provide all

Peripherical equipment of a boiler- house: